|

I. Introduction
The research staff of the USDA Forest
Service - Coweeta Hydrologic Laboratory as well as the University of
Georgia and other cooperating institutions have been archiving soil and
plant tissue samples since 1970. Historically, scientists have been solely
responsible for the collection, analysis, and long term storage of
samples. In an effort to better organize and to make these valuable plant
and soil samples more accessible, a sample archive was established at
Coweeta in 1997. Online documentation below outlines the current policies
and procedures for the addition to and usage of samples in the physical
archive.
II. Facilities
Location of the archive is in the data vault located next to the Coweeta
LTER Dormitory. The structure is a concrete and stone building designed to
be fire and weather resistant. The interior consists of two rooms both of
which have large doors with hermetic seals. The dimensions of both rooms
are approximately 3m by 4m. Each room has numbered shelves that correspond
to numbers in the archive database. The building is not used for drying,
sieving or grinding samples, temporary storage, or for any purpose other
than archiving of samples. It is recommended that all samples be stored in
glass jars because there is no heat or humidity control available at this
time.
III. Archival Procedures & Assistance
Currently housing over 17,000 samples, Coweeta LTER's sample archives are
a resource available to researchers, visiting scholars, and students.
Please read the information provided below carefully.
Inquiries and questions help from
Coweeta LTER:
Please send inquiries to the attention of: Physical Archive Manager,
Coweeta LTER -
Jim
Deal
Sample Preparation
Soil - all soil samples should be air dried and sieved to 2mm. They should
be stored in glass jars with screw caps. Plastic bags are not recommended
because they break down over time and are subject to rodent attack. Each
sample jar will have a permanent label complete with sample ID and
barcode.
Plant tissue - all plant tissue should be
oven dried and ground to 1mm. Samples should be stored in glass jars or
glass vials with screw caps. Exceptions would include tree cores which
could be stored in plastic straws or mounted on wooden blocks to preserve
the time sequence. Tree disks can be stored in large cardboard boxes and
arranged so that air can flow around the samples.
Minimum recommended amount of sample to
archive is 100 grams of soil or 20 grams of ground plant tissue.
Toxic Samples Policy
Toxic samples will not be accepted.
Submission of Samples:
Only samples with adequate
documentation are accepted for permanent storage. The contributing
scientist is responsible for ascertaining that permanent storage of each
individual sample is desirable. Forms for the documentation of physical
samples may be obtained from the
Physical Archive Manager. When a scientist wishes to contribute a
collection of samples for permanent storage, he/she should complete and
submit the online
Sample Form. If the samples are accepted for permanent
storage, the researcher will be notified, and the samples should be
brought to the storage building at Coweeta.
The Physical Archive Manager will then assign barcodes and enter the
documentation into the database.
Subsampling of Archives:
Subsampling of permanently stored samples will be restricted to 10% or
less of the remaining material in each sample. Contributing scientists
have unrestricted access to their samples as long as they remain
associated with the Coweeta LTER project. However, they must inform the
Physical Archive Manager of any subsampling. Other scientists who wish to
use the permanent samples must complete and submit the online
Subsample Form. The Physical Archive subcommittee will
decide if subsampling can be done. The Physical Archive Manager will
exercise quality control over subsampling.
|